When cutting thin materials the sheet must be supported during measuring, being prevented from hanging down, until it touches the back gauge rail.

System 1
Decoiling, feeding and cut to length

System 2
Decoiling, feeding, slitting and cut to length and System 2 RCO
Decoiling, feeding, slitting, cut to length or recoiling

System 3
Decoiling, straightening, feeding and cut to length

System 4
Decoiling, straightening, feeding, slitting and cut to length and System 4 RCO
Decoiling, straightening, feeding, slitting, cut to length or recoiling

System 5 RCO
Decoiling, feeding, slitting and recoiling

For pricing or a quote contact sales@mftsa.co.za.

Compact:

Profi

 Turbo

For pricing or a quote contact sales@mftsa.co.za.

The Systems

Slitting Capacity - Cutting Lines

Pairs of slitting blades

If trimming coils from (1,25 meter / 49 inches)up to (1,5 meter / 60 inch), use the capacity on the “dash line”.
In order to obtain correct sheet thickness information, replace the 100% with steel capacity from desired CTL line.
The reduced or increased percentage figures refer to maximum material thickness.

For pricing or a quote contact sales@mftsa.co.za.

Options

	FOOTPEDAL The foot pedal is used for remote control of the feeding. This is to simplify the process of changing coil.
	DEVICE FOR ADDING PROTECTIVE FOIL Device for adding protective foil on top side and / or lower side of the material. This device can be equipped with a brake in order to adjust the tension and is mainly used for sensitive material.
	SLITTING UNIT All our lines can be fitted with a slitting unit that consists of upper and lower rolling knives. The unit can be equipped with 1–8 pair of knives. The slitting unit can be activated or de-activated by moving the upper knives up or down via a hand wheel.

The knives on our slitting units are easily adjusted horizontally and they all have two cutting edges to double the lifespan. Minimum distance between the knives is 50 mm (2”). Shafts are precision ground and hardened. Knives are tool steel.
Tolerance betwen shafts and knives are 0,01 mm ( 0,0005” ) which guarantees accurate slitting.

For pricing or a quote contact sales@mftsa.co.za.

Manual Decoilers 1 - 5 Tons Capacity

Cradle	DO2-12	DC 5
STANDARD FEATURES - 4 supporting rolls - Fixture for transportation of pallet jack	STANDARD FEATURES - Manual decoiler with single frame and expandable mandrel - Brake system, manually adjusted	STANDARD FEATURES - Manual decoiler with mandrel - Expandable mandrel with side guides - Brake system, manually adjusted