Waterjet > Suprema >

Waterjet SUPREMA DX 510

The system corrects for taper and achieves wall straightness and the highest possible cutting speeds, by compensating through CNC the inclination, up to two degrees, and orientation of the high pressure waterjet.

This ensures a high quality part at a low cost.

During the compensation, the Jet is also directed towards the piece in order to reduce the Tail Delay effect and the acceleration-deceleration ramp times in the corners, for faster and more economical cutting cycles.

 

                                                                                    


Email Us:  sales@mftsa.co.za
Call Us: +27 (0) 83 273 8322