SAMCO Automotive Door Panel & Cut-to-Length Line
Overview
This is a continuous automotive door panel line and parts containing different web lengths can be formed in the same
rollformer with minimal operator adjustment. Coil material is loaded onto the uncoiler, fed into a flattener after edge
trimming, cut to desired length and fed into the rollformer. The formed coil strip exits in a run-out conveyor.
Key Features:
1 - 10K Single Ended Uncoiler with Full Time Drive, 52” Mandrel Length, and Hydraulic Expansion
2 - Edge Trimmer mounted on Flattener Table, adjustable for variable widths
3 - Length Control System with Stop and Go operation
4 - Pick and Place operation (for blanks) precedes 15’ 6” long Launching Conveyor to Rollformer
5 - Samco Duplex Rollformer with Stub-Shaft Design (RAFTED) with factory laser alignment of
stands and shafts
6 - 10” long Exit Conveyor
Features / Benefits
| Features | Benefits |
| 10000 lb Single Ended Uncoiler |
Full Time Drive and Hydraulic Mandrel Expansion |
| Edge Trimmer | 2 adjustable trimmer blades for different widths driven by Flattener Drive |
| 2 Scrap Choppers | Placed left and right to pick up the scrap |
| Cut to length Shear Cut Off Press | Able to cut up to 52" strip width |
| Pick and Place Operation | Allows blanks to be stacked and collected prior to entering the Roll Former |
| Universal Rollformer | SDU 2" - Rafted Model Duplex Stub Shaft with powered width adjustment by AC motor |
| 10' Run Out Conveyor | Runs the finished products to buffer or stacking station |
Options
Powered shifting mechanism provides power to Scissor Lift to perform Cut To Length Operation
Scissor Lifting Table
10,000 lb Coil Car
